A morning call starts, the webcam is dim, and a desk mat setup is what steadies the surface: the keyboard stops sliding on the bare desktop, the mouse gets room to move, and the desk underneath stays protected from scratches, stains, spills, heat and scuffs. This guide walks through the setup in order, from measuring the desk to placing the mat, arranging the keyboard and mouse, routing cables and keeping the surface clean. The steps work for a spare-room desk, an apartment corner or a kitchen table.
OfficeKitHQ earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
The quick answer: desk mat setup
A desk mat setup means choosing a mat that fits the desk, laying it flat in the middle of the work area, and arranging the keyboard, mouse and cables on top of it. Measure the desk before ordering, so the mat covers the keyboard and mouse without hanging over the edge. Place the mat with the smooth side up and the grip side down, set the keyboard and mouse where the hands rest without reaching, and run cables along the back edge where they stay out of the way.
Measure the desk
Start with the desk itself. Clear the surface, then measure the width from left to right and the depth from the front edge to the back edge, and note where the monitor stand, lamp and any riser sit. A mat should leave a margin of bare desk around it, so the edge of the mat does not catch on sleeves or papers. As a size reference, the YSAGi leather desk protector (on Amazon) lists 31.5 x 15.8 in, a large size that holds a keyboard and mouse on one surface with room for a notebook beside them. Compare that size with the desk measurements before ordering, and check the size chart in our desk mat sizes guide. Our best large desk mat guide compares large sizes for a full desk. A mat that is wider than the desk will hang over the edge and curl, while a mat that is too small leaves the mouse sliding onto the bare desktop.
Lay the mat flat
Lay the mat on a clean, dry desk and let it lie flat before placing anything on it. Put the smooth PU leather side up and the suede side down, since the suede back grips the desktop and keeps the mat from sliding while typing. YSAGi claims the suede back raises friction resistance by 70%, which is the grip that holds the mat still under the keyboard and mouse. Smooth out any curl at the corners by pressing them flat with a palm and leaving the mat empty for a while, so it settles before the gear goes back on. If the mat still lifts at a corner, turn it over, check for dust or crumbs underneath, and wipe the desktop clean before laying it down again.
Place the keyboard and mouse
Set the keyboard in the middle of the mat, with the mouse to the side where the hand rests without reaching. The mat surface also works as a large mouse pad, so the mouse can travel across the mat without running onto the bare desk. Leave space in front of the keyboard for the hands to rest on the mat, and space behind it for cables to pass without lifting the mat edge. A mat that holds the keyboard and mouse on one surface keeps the whole typing area steady, and our best mouse pad guide covers pads for a smaller footprint. If the mouse feels slow or sticky on the leather, wipe the surface with a cloth and check for dust before changing any settings.
Route the cables
Cables belong behind the mat, not across it. Run the keyboard, mouse and monitor cables along the back edge of the desk, then bring each one up to its device in a short, straight line. A cable that crosses the mat will lift the edge, catch the mouse and pull the mat out of place during the day. Keep the power brick and hub on the desk or on the floor behind the desk, with enough slack that the mat can move a little without tugging a plug loose. When the cables are settled, the mat lies flat, the keyboard stays put and the mouse has a clear run from edge to edge.
Clean and care for the mat
The YSAGi mat is waterproof PU leather, so daily cleaning is a quick wipe. Use a cloth for liquid, dust, grease and dirt, and use a wet cloth when the mat is very dirty. Let the surface dry before placing the keyboard and mouse back on it, so moisture does not sit under the gear. Keep pens and sharp objects off the mat, since the leather surface protects the desk from scratches and scuffs but can mark itself. Store the mat flat when it is not in use, and keep it away from heat, so it holds its shape for the next setup.
FAQ
What size desk mat should I get?
Measure the desk first, then match the mat to the space the keyboard and mouse need. As a reference, the YSAGi leather desk protector lists 31.5 x 15.8 in, a large size that holds a keyboard and mouse on one surface.
Do desk mats damage the desk underneath?
No, a mat protects the desk: the YSAGi mat is made to guard against scratches, stains, spills, heat and scuffs. The suede back grips the desktop, so the mat lifts off cleanly when it needs moving. Check the surface underneath now and then for dust, and wipe it before laying the mat down again.
Can I use a desk mat as a mouse pad?
Yes. The YSAGi mat surface works as a large mouse pad, and the mouse can travel across the mat without running onto the bare desk. See our best mouse pad guide for pads that suit a smaller footprint.
How do I clean a leather desk mat?
Wipe the PU leather surface with a cloth for liquid, dust, grease and dirt, and use a wet cloth when the mat is very dirty. Let the surface dry before placing the keyboard and mouse back on it. The mat is waterproof, so a spill wipes off instead of soaking in.
More for your workspace
See every Desk Mats and Pads guide and all Desks and Desk Lighting guides.
See the best large desk mats, the desk mat sizes, the best keyboard trays and the best under-desk footrests.





