Skip to content
We independently pick everything we recommend. We earn a commission when you buy through our links, at no extra cost to you. Learn more ›

Home office gear, compared spec by spec.

Amazon Black Friday Week deals

Desk Height Calculator

This calculator turns four tape-measure numbers into the heights to look for when you set up or shop for a home office: chair seat, desk surface and keyboard when sitting, the same when standing, and where the top of your monitor should sit. It works from your own body, not from your overall height, because two people of the same height can have very different leg and arm lengths.

Turn on JavaScript to use the calculator. The steps below show how to work out each height by hand with a tape measure.

The numbers filled in are examples only. Replace them with your own measurements.

How to measure

You need a tape measure and someone to read it, or a wall and a pencil. Wear the shoes you work in, and sit on a firm, flat chair or stool.

  1. Lower leg: sit with your feet flat and your thighs level. Measure from the floor to the back of your knee.
  2. Elbow above seat: sit upright, let your upper arms hang at your sides and bend your elbows so your forearms are level. Measure from the seat to the underside of your elbow.
  3. Eyes above seat: sit upright and look straight ahead. Measure from the seat to the outer corner of your eye.
  4. Standing elbow height: stand straight with your arms in the same position. Measure from the floor to the underside of your elbow.

The two optional boxes help with the details. Keyboard height is the distance from the desk to the top of the middle row of keys, which the calculator takes off the desk height so your hands, not the desktop, end up at elbow level. Your desk now is for a desk that does not adjust: the calculator compares it with the height you need and tells you how to make up the difference.

How the calculator works

It places each part of the setup the way the U.S. Occupational Safety and Health Administration (OSHA) describes in its Computer Workstations eTool:

  • Chair seat height = lower leg. OSHA says the chair height is right when the whole sole of the foot rests on the floor with the back of the knee slightly higher than the seat. Setting the front of the seat at your lower-leg measurement, or a little under it, gives that.
  • Keyboard home row = seat height + elbow above seat. OSHA’s checklist describes forearms about parallel to the floor, with the elbows near the body at about 90 to 100 degrees, so the keys sit at the height of your bent elbow.
  • Desk surface = keyboard height − keyboard thickness.
  • Top of the screen = seat height + eyes above seat. OSHA says to place the monitor so the top line of the screen is at or below eye level, so treat this number as the highest the top of the screen should go.
  • Standing desk and keyboard use your standing elbow height the same way. The standing screen height adds the gap between your elbow and your eyes, measured sitting, to your standing elbow height, so it is an estimate.

A worked example

Say your lower leg is 18 inches, your elbow sits 9.5 inches above the seat, your eyes are 30 inches above the seat, your standing elbow height is 42 inches and your keyboard is 1 inch tall at the home row.

  • Chair seat: 18 in.
  • Keyboard home row sitting: 18 + 9.5 = 27.5 in, so the desk surface goes at 27.5 − 1 = 26.5 in.
  • Top of the screen sitting: 18 + 30 = 48 in from the floor, or a little lower.
  • Standing: keyboard at 42 in, desk surface at 41 in, and the top of the screen at about 42 + (30 − 9.5) = 62.5 in.

If the same person has a fixed 29-inch desk, it is 2.5 inches higher than they need. Raising the seat to 20.5 inches brings their elbows up to the keyboard, and a footrest about 2.5 inches tall keeps their feet flat.

Using the numbers when you shop

  • Standing desks list a lowest and highest height. Look for a range that reaches below your sitting desk height and above your standing desk height, with a little room on each side for different shoes.
  • Office chairs list a seat height range, usually measured to the front of the seat. Your seat height should fall inside it, not at the very edge.
  • Monitor arms and risers list how high they lift the screen. Check that the top of your screen can reach the height above, and remember OSHA’s preferred viewing distance of 20 to 40 inches (50 to 100 cm) from your eyes to the screen.
  • Fixed desks need room underneath. OSHA says the clearance for your legs under the desktop should generally be between 20 and 28 inches (50 to 72 cm).
  • Footrests and keyboard trays fix a desk that is too high for you. Match the footrest height to the difference the calculator gives.

Questions

What is the standard desk height?

There is no single right height for everyone. The right desk height is the one that puts your keyboard at your elbows while your feet rest flat, which is what the calculator works out from your own measurements.

Why not just enter my height?

Leg and arm lengths vary a lot between people of the same height, so a chart based on height alone may not fit you. Four quick measurements give a better answer for you.

Should my desk or my keyboard be at elbow height?

Your hands on the keys. If your keyboard is tall, the desk itself needs to sit a little lower than your elbows. That is why the calculator asks for keyboard height.

How high should a standing desk be?

Set it so your forearms are level when your hands are on the keys, the same way you would sitting. For most people that puts the desktop just under standing elbow height. Measure in the shoes you will stand in.

Where should the top of my monitor be?

OSHA says the top line of the screen should be at or slightly below eye level, at least 20 inches away.

Sources