Monitor stand size comes down to the width of the monitors, the depth of the desk, and the height that puts the top of the screen at or slightly below eye level. A stand that is too narrow leaves a monitor hanging over the edge, a stand that is too deep eats the desk, and a stand that is too low leaves the screen where it started. The steps below show how to measure the monitors and the desk, pick a width that fits, and set the height, using figures from a monitor stand listing.
OfficeKitHQ earns a commission when you buy through links on this page, at no extra cost to you. As an Amazon Associate I earn from qualifying purchases. Affiliate disclosure.
The quick answer
Measure the monitors side by side, then measure the desk depth from the front edge to the wall or the back edge. Pick a stand at least as wide as the monitors with a little room to spare, deep enough to hold the monitor bases without overhang, and tall enough to lift the screen so the top sits at or slightly below eye level. The WESTREE dual stand (on Amazon) in these listings measures 35.8 in wide, 10.2 in deep and 4.92 in high, and fits 2 monitors, which is a useful yardstick: a stand near that width suits a pair of monitors, while a narrower stand suits a desk with a lone monitor.
Monitor stand size at a glance
| Stand | Width | Depth | Height | Monitors |
|---|---|---|---|---|
| WESTREE Dual Monitor Stand Riser | 35.8 in | 10.2 in | 4.92 in | 2 |
Figures as stated in the listing. Width is the side-to-side measurement, depth is front to back, and height is how far the stand lifts the screen.
Step 1: Measure the monitors
Set the monitors side by side the way they will sit on the stand, then measure across the full width from the outer edge of the left screen to the outer edge of the right screen. Add a little room at each end so the screens do not sit flush with the edge of the stand. Compare the result with the stand width: the WESTREE dual stand measures 35.8 in wide and fits 2 monitors, so a pair of monitors that measures wider than that needs a wider stand. For a desk with a lone monitor, measure the width of that screen and pick a stand that covers it with room to spare. Note the monitor bases too: a stand must be deep enough for the bases to sit fully on it, and the WESTREE stand measures 10.2 in deep.
Step 2: Measure the desk
Measure the desk depth from the front edge to the back edge, and check what sits behind the desk, such as a wall or a cable tray, that would limit how far back the stand can go. A stand that is deeper than the desk leaves no room for a keyboard in front of it, while a stand that is too shallow leaves the monitor bases hanging over the front edge. The WESTREE stand measures 10.2 in deep, so it needs that much desk depth plus room for the keyboard. Also measure the free width on the desk: the stand must fit between the desk legs or the side panels with room to spare. A stand that also stores supplies underneath, as the WESTREE listing describes, needs clearance below the top board for the items stored there.
Step 3: Pick the height
The right height is the one that lifts the screen so the top sits at or slightly below eye level when seated in a normal working position. The WESTREE stand measures 4.92 in high, which is the lift it gives the screen. If the screen still sits too low on a stand of that height, look for a taller riser or a monitor arm, which adjusts the height instead of holding it at a set height. If the screen sits too high, a shorter stand or no stand at all may fit better. Check the height with the monitor in place before loading the stand with supplies, since the screen position is what matters.
Step 4: Check the weight and the base
A stand must hold the monitors without flexing, so check the stated load before buying. This listing states no load figure, only that the stand uses thick solid steel legs, so take the load as unstated and check with the maker when the monitors are heavy. The stand itself should sit flat: the WESTREE listing includes anti-slip pads on the bottom, which the buyer can choose to install. Assembly is stated as 2 minutes with pre-drilled holes and all tools and parts included, per the listing. Keep the stand clear of the desk edge and check that it does not slide when the monitor is adjusted.
A stand for each screen
A dual stand such as the WESTREE, which fits 2 monitors, keeps a pair of screens at the same height on a shared board. Separate stands give each screen its own height, but they take more desk depth and leave a gap between the screens. For a desk with a lone monitor, a stand sized for that screen leaves more desk free than a dual stand. The WESTREE stand also serves as a printer stand, a laptop riser or a TV stand, per the listing, so a stand that outlives the monitor setup can move to another job on the desk.
FAQ
What size monitor stand do I need for a pair of monitors?
Measure the pair side by side and pick a stand at least that wide. The WESTREE dual stand measures 35.8 in wide, 10.2 in deep and 4.92 in high, and fits 2 monitors, so a pair wider than that needs a wider stand.
How high should a monitor stand be?
High enough to lift the screen so the top sits at or slightly below eye level. The WESTREE stand measures 4.92 in high. If that lift leaves the screen too low, look for a taller riser or a monitor arm.
How deep should a monitor stand be?
Deep enough for the monitor bases to sit fully on it with room to spare. The WESTREE stand measures 10.2 in deep. Measure the desk depth first, and leave room for the keyboard in front of the stand.
How long does it take to assemble a monitor stand?
The WESTREE listing states 2 minutes with pre-drilled holes and all tools and parts included.
Can a monitor stand hold a printer or a laptop?
The WESTREE listing describes the stand as a printer stand, a laptop riser or a TV stand as well as a monitor stand. Check the stated load for the item placed on it; this listing states no load figure.
More for your workspace
See the monitor arms, the monitor stands, the metal monitor risers, the standing desks, the office chairs and the dual monitor setups.





